JDSU NT850 User's Guide download pdf (Page 62)

Chapter 4 Performing Cabling Tests

Performing Remote Mapping Tests

46 LanScaperPRO Network Tester User’s Guide

Figure 19 The Mapping Test Results screen, pre-

test

6 Press the TEST key to begin the test.

A new area appears at the bottom of the screen: the

the Remote ID area on the right. A bar moving across

the Remote ID area indicates the test is in progress.

Upon completion of the test, the number of the

attached remote identifier is displayed on the

Mapping Test Results screen. In addition, the results

of the open-ended cable test are displayed to provide

status on all pairs found in the cable. (For more infor-

mation on cable test results, look under step 5 under

“Performing Cable Tests” on page 41.) The pins that

were found to be connected to the remote identifier

are shown as connected to M. Any cable faults found

that prevented detection of the identifier are

displayed rather than the number.

7 Disconnect the cable just tested from the tester.

8 Repeat steps 2-7 until mapping of all cables to be

mapped is complete.

LanScaperPRO_User_Guide.book Page 46 Friday, January 25, 2008 1:14 PM

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 105 106

No comments

JDSU NT850 User's Guide Page 62