JDSU TP300 User's Guide download pdf (Page 13)

10

Instructions for Use

Resi-Tester™ powers off automatically 9

minutes after the last button press in cable

testing modes and after 2.4 hours in tone

mode. Be sure to install a battery if using

for the first time, see battery installation

section.

Cable Testing

To Test a Patch Cable (see caution about

cables with bad plugs above)

Plug one end of patch cable into main

unit.

Plug other end of cable into remote unit.

Press TEL or NTWK as appropriate for

the jack the patch cable is connected

to. The Resi-Tester™ will turn on and

begin a test. If tester was already on,

press TEL or NTWK to initiate a new

test. Results are invalid if a cable is

attached during a test in progress.

To turn Resi-Tester™ off, press COAX

button.

1)

2)

3)

4)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Comments to this Manuals

No comments