JDSU TP607 User's Guide download pdf (Page 5)

2

Description

The LanRoamerPRO

™

has an LCD display and

four momentary buttons. One remote attaches

to the main unit for storage or patch cable

testing. The rubber end cap at the bottom is

the battery compartment cover.

The LanRoamerPRO

™

starts in an off condition

when cable testing with a remote. This yields

maximum battery life and takes advantage

of the fact that the auto-on feature effectively

synchronizes the test cycle to the cable being

connected for results in 2 seconds. The tester

powers on and testing begins automatically

when a connection from the main unit to the

remote is sensed. The tester will automatically

power off within 5 seconds of the cable being

disconnected.

Upon completion of the test, the wire map

display, ID and any faults are displayed. The

top line of numbers on the display represents

the connector pins on the main unit. The

second line of pin numbers is the connector

pin numbers of the remote, normally being the

same as the top line for a normal data cable. If

there is a miswire, the numbers on the second

line will indicate the pin numbers detected. If

no connection was detected for some of the

pins, the second line will be blank in those pin

locations. If a short is detected, the second

line will have a flashing “x” in that position and

the specific short condition displayed on the

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments